Basecoat Slide Mailer with acrylic gesso
Paint with Lumiere White Pearl
Stamp snowman and Let It Snow with black permanent ink
Allow to cure overnight, or heatset
Color snowman with brush markers
stamp snowflakes with marker Direct to Rubber.

Stamps used:
snowman #3779
Let It Snow #3198
snowflake #3777

Stamp images on white cardstock with permanent black ink
heat set ink
Paint with Peerless watercolors
Cut out images

Stamps used:

#3758, #3759, #3760, #3761

Stamp images on white cardstock with permanent black ink heat set ink.
Paint with Peerless watercolors
Cut out images
Sandwich both sets back to back inbetween

2 glass slides Wrap with silvered copper foiling tape, attaching wire loop to beginning edge of tape and centering loop on top.
Allow tape to overlap loop and slit tape on second end, position each side of slit tape on each side of loop.
Use a toothpick to push tape down around loop
Use a wooden craft stick to burnish tape around edges of slides.

Stamps used:

#3762, #3763, #3764, #3765

Same steps as above.

This one was colored with Sharpie permanent markers

Snowflake is stamped with Fluid Chalk Inks

This one was colored with Glaze pens,

coloring one section at a time and letting it dry

before coloring next to it.

Working wet into wet, the colors can be blended

The scarf is a mix of yellow and green.

The cheeks are mostly clear with a bit of pink

Stamp images on acetate

Color from reverse with glaze pens.

color one section at a time and let dry before

coloring next to it. Cut out images.

Cut silver Mirricard cardstock to place behind image

Assemble same as above, between 2 glass slides.

To make loop, use a round nose pliars or wrap wire around a skewer or dowel.

22 gauge or 24 gauge wire